Delta Touch Kitchen Faucet Problems

Try removing the aerator.

Delta touch kitchen faucet problems.

Connect the faucet or battery pack to anything that is acting as an earth ground e g house wiring or water lines. If you remove the aerator and still don t have any water shut the hot and cold valves off under the sink and remove the supply hoses. To address the problem first remove the delta faucet parts by pulling out the ball assembly. If none of the touch areas respond to touch activation.

Should your delta touch 2 o technology faucet be activated accidentally the faucet has an automatic shut off feature that will stop the flow of water after four minutes of no activity. If you get plenty of water coming out of the faucet then soak the aerator in vinegar or calcium lime rust for a while and reinstall and test. Disconnect your terminal from the batteries and make sure that your solenoid valve is connected properly. Metal sinks are fine install the faucet within 4 of a metal backsplash behind the faucet.

What to do if your led indicator isn t working what to do if your led indicator is flashing red how to disable touch activation what to do if your touch2o faucet is turning on and off by itself. Disconnect the solenoid from the battery pack and wait for at least 30 seconds for the solenoid to be reset. As with any technology issues can arise. Install the faucet on a metal countertop.

Some debris and or foreign material in the lines may be too large to pass through the faucet whether it is a kitchen lavatory or tub shower faucet. If you have a two handle faucet you will find a cylinder shaped cartridge instead of a ball assembly. When the touch sensor or motion activated faucet quits working the first place to check is the battery compartment. Make sure cold water flows first and that the rotational handle limit stop is properly set.

For any number of reasons the faucet may quit working. This way you will have water however the touch problem might still persist.